Close
Car Questions
RepairPal is your advocate for car care advice and guidance

bought a motor from junk yard found out its stick shift my bmw is an automatic

(1993 BMW 325is)
in Covina, CA on July 18, 2011
how hard will it b to put the torc converter on the stick shift flywheel
Displaying 1 answers & 0 comments
Popular Answer
You cannot put a torque converter on stick shift flywheel. Hopefully the flywheel of your engine will swop and mount onto the back of the engine you just bought. Replace the rear crankshaft oil seal while you have the flywheel/flex plate off. Remove the valve cover and maybe the oil pan and see if the motor is any good prior to spending all the time to install it and then find out its bad. Do you have a workshop manual? Alldata is very good. The information is year make and model specific, covering repair procedures, torque specifications, fluid capacities and specifications, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
the vibration is enough to dislodge the steering colom lock. it also can come on at 45mph.when. i take a bend to the ...
when I first start out acts normally then as time goes on it gets worse. I have had days where I was ok up until 60 t...
Didn't find what you were looking for?