Car Questions
RepairPal is your advocate for car care advice and guidance

92 van stalling after replacing distributor cap/rotor /plugs/wires and fuel pump?

(1992 Chevrolet Astro)
in Chandler, AZ on January 23, 2011
stalling two weeks after replacing these parts. This problem occurs steady low speed and on acceleration?
Displaying 2 answers & 1 comments
Popular Answer
on January 23, 2011
Sounds like need to recheck all of your work, you may have left off a vacuum line etc. Did you replace the pickup screen for the fuel pump and did you use a factory quality pump? Did you replace the fuel filter as well?
on January 23, 2011
Thank for your reply, fuel filter was also replaced. Going to check fuel pressure next. Thanks again.
If you didn't have the stalling problem before the work, you should recheck what was done. The first place I recommend checking is the fuel pump fuel and items related to fuel flow. Low fuel volume could cause stalling.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
had water pump replaced and thermostat still getting hot now being told it could be heater core. had a lot of rust. ...
Didn't find what you were looking for?