Close
Car Questions
RepairPal is your advocate for car care advice and guidance

2.8L Diesel p0069 MAP sensor and BAR sensor correlation

(2006 Jeep Liberty)
of Good Guys Diesel in Santa Cruz, CA on January 13, 2011
We have a 2005 Jeep Liberty 2.8L diesel. We have cleaned the intake and egr as well as done a timing belt service. We have also swapped the map sensor and fuel filter. We are getting a P0069 MAP sensor and BAR sensor correlation and the pedal position sensor light is flashing. Any ideas where to go next????
Displaying 2 answers & 2 comments
Popular Answer
on January 14, 2011
Have you replaced the MAP Sensor? Typically a MAP Sensor code is caused by a defective MAP sensor or its wiring.
of Good Guys Diesel on January 14, 2011
yes we did replace the map sensor...
on February 25, 2011
well, maybe you should go to maaco.
of Good Guys Diesel on February 25, 2011
maaco is a body shop that has nothing to do with the work on this car.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
The truck runs fine had to replace that BCM about 3 months ago because my lights and my windows wouldn't work. After ...
I have a 2010 jeep liberty sports, it is over heating and not blowing heat in the cabin, I have replace the thermost...
Didn't find what you were looking for?