Close
Car Questions
RepairPal is your advocate for car care advice and guidance

1994 Dodge caravan SE... idale but not run

(1994 Dodge Caravan)
in Ruckersville, VA on October 14, 2010
I have replaced cam senser, fuel pump, main computer, coil pack, trann modulser value, fuel filter, throller body control switch, pressure valve, it isles but when gave gas it spulters, back fires, and will not run... it started by cutting out while going down road, then started cutting out and just quit... have put megga money and no station can find out what it is???
Displaying 2 answers & 0 comments
Popular Answer
on October 17, 2010
You need to find a good mechanic who knows those cars.
Here's a directory link for you:
http://repairpal.com/dodge-repair-in-ruckersville-virginia
on November 08, 2010
You should always start with the basics. The Spark Plug and Ignition Wires should be the first things replaced. The Crank Position Sensor is another part, which when intermittent will cause stalling, hard or no-start condition. Lastly, depending on your vehicles mileage, the Timing Chain may have stretched to the point that the Crank Position Sensor and the Cam Position Sensor are no longer in sync. If this is the case, the engine will not run.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
pedal go to the floor when going after stoping and picks up speed
Why my heat blowing cold air now that I got intake manifold gasket put on
Didn't find what you were looking for?