Q&A

2002 Chrysler Sebring

Question: wont start

• Sensor Failure Inside Distributor May Cause Stalling/Starting Issues
  Sensor failure inside the distributor can cause intermittent stalling or a failure to start. In addition, the wires to the distributor are susceptible to internal damage, which can cause the same s...

  Common Problems > Chrysler Sebring

• car wont start
  ...p, oil pump, timing chains and set timing,on my 2.7 engine DOHC, put it all back together, car wont start, It has spark in cylinder 2 and 5 only what could be wrong

  Q&A > Chrysler > 2003 Chrysler Sebring

• Died wont start
  Pulling out of my drive way and the nose scraped a little as i started up the road it sputtered like it was out of gas and died, wouldn't start back, but turns over. Never had a problem like this b...

  Q&A > Chrysler > 1996 Chrysler Sebring

• CAR DIES, WONT RESTART UNTIL HOURS LATER
  Bought code scanner and get code P0455. It just passed smog so assume its not gas cap. Have changed fuel filter, also plugs, fuel pump relay, battery. It has died at speeds up to 40 miles per hour....

  Q&A > Chrysler > 1999 Chrysler Sebring

• Can anyone help
  I have a car that wont start my buddy said it might be the ignition coil or engine control module. When this part goes bad what happens? Does it make the car cut off and say its running hot, when i...

  Q&A > Chrysler > 2001 Chrysler Sebring