wiring from blower motor to??? on 1999 Jeep Wrangler

Purchased jeep,one wire from blower motor was disconnected and there were only two visible(one being ground)set up toggle as quick fix from battery(it melted toggle)How do I hook up the wiring from blower to where??Or what do I need to get it working correctly?I know the motor does work..

by in Fort Wayne, IN on September 17, 2009
1 answer
ANSWER by on September 17, 2009
The blower motor as you found is in the engine compartment behind the battery, the fuse that protects it is 40 amps, the toggle switch used was probably under rated to carry that high a load. The blower motor if it is seizing could draw higher current perhaps it is bad. The blower motor has a controlling relay under the dash attached to the heater core/air conditioning evaporator housing under the dash. There is also of course the controlling switch and a blower motor resistor that controls the speeds. When the resistor pack fails it usually results in the motor working only on high speed. The resistor is also located under the dash in the heater core hosing and is located with two bolts securing the resistor pack.
2 people like thisFlag inappropiateReply
Related Items:
Ok you have answered some of my questions but the one that remains about the blower motor is..I have two wires a red and a black(black being ground)the red one is disconnected(these wires come from...
looks to me like the blower motor has failed or the fan switch has failed. Wiring diagram shows a blower motor relay but I can't find it? I have changed the 40 and 10 amp fuses even though they we...
Blower for ac/heater only works on highest speed
I just bought this jeep wrangler and found out nothing happens when the blower control is turned on ,no heat,no noise,nothing. All fuses check ok the relay checks ok, any body know whats going on?
After the fan is blowing for about 20 to 30 mins with the heat on on any setting it will start to turn on and off the finally not blow at all. So I shut the car off and then its fine again until an...