Q&A

1998 Nissan 200SX

Question: will not start

Question

iky, 1.6L 4 Cylinder, Newberg, OR, February 19, 2010, 18:41

 Rookie

replacede the crankshaft location sensor but car will not start, add gas to plugs and it just sputters. is the mass airflow sensor the problem?

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  Bret Bodas February 19, 2010, 19:36
  

   Master

  It is impossible to tell what the problem is based on the information you give. Without knowing the fuel pressure, fuel mixture readings, fault codes and injector operation, we cannot even start to guess as to what it might be.
  Flag This
  Like0
• Reply

  iky, February 19, 2010, 20:01
  

   Rookie

  hang on ill run it down to a mechanic and find out, thanks
  Reply
  Flag This

• Car wont Start
  We got a 1995 nissan 200sx and it ran fine. Then one day we were at a Wal-Mart and we came out and it wouldnt even try to start. But we pushed started it and it ran fine. We thought it was the star...

  Q&A > Nissan > 1995 Nissan 200SX

• idles smooth,but will not take any kind of throttle without running rough
  does not throw any codes, just started getting worse and worse.

  Q&A > Nissan > 1995 Nissan 200SX

• no start
  when i started my car it didnt turn my lights all came on but i didnt hear the motor start just silence not even like the ignition trying too start the car

  Q&A > Nissan > 1997 Nissan 200SX

• Rough idle and flutter
  I have a 95 nissan 200SX 1.6 automatic and it idles kinda rough and if i give it too much gas it flutters like i hit the rev limiter but if i easy into it it does fine. i took off the distributor c...

  Q&A > Nissan > 1995 Nissan 200SX

• Wont turn over
  My 98 200sx died out on me after I was sitting at a stop light. The light turned green and I started accelerating around the corner going right when I let off the gas a little then when I started t...

  Q&A > Nissan > 1998 Nissan 200SX