» » »

GMC Q&A

Ask Your Question

2000 GMC 3500 Pickup Question: where is the Injector Driver Module located? it's a 6.5 diesel.

 

Question

lemon7, Lake Station, IN, November 13, 2012, 10:42
 Rookie

This part is heating up and causing the truck to not start or start and run for awhile then quit. sometimes it will restart after it sets for awhile

3 Answers
Flag This
  • Answer #1

    Greg's Orange Auto (13991 Answers) , Orange, CA - (714) 361-9386
    globalhelper November 13, 2012, 12:54
     Master

    sorry all data gives no location on that but says 3.5 hrs to repl

    Reply
    Flag This
  • Answer #2

    November 13, 2012, 18:29
    Profile_thumbnail
     Master

    possibly in the PCM

    Reply
    Flag This
  • Answer #3

    July 24, 2013, 08:11
     Rookie

    The PMD (Pump Mounted Driver) Is mounted on top the Fuel Pump under the intake manifold.
    This is likely the most common problem with 6.5's dieing and or not starting.
    No need to remove manifold to replace, You buy a relocation kit with a heat sink.I installed mine inside front bumper on the provided "stand outs" by one of the fog light holes (Gets plenty of air and stays cooler than original position.)The hardest part is reaching down in front of manifold to unplug the old PMD harness.Install the new harness to this connector and route it down in front. Leave the old PMD where it is. It took me about an hour to replace, and I have had no more problems.

    Reply
    Flag This