Q&A

2006 Honda Accord

Question: Was Work Done

Question

Macho, 2.4L 4 Cylinder, Lakeland, FL, March 05, 2010, 14:43

 Rookie

How can I tell if work was done as stated? I had rear pads replaced and rear rotors machined on my Honda. My car feels the same as before. What would the machined rotors look like?

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  Valleyautotech March 05, 2010, 14:53
  

   Master

  They should be clean and smooth where the pads come in contact
  Reply
  Flag This
  Like0
• Best Answer
  Visitor, March 06, 2010, 10:13

  if by "feels the same as before" you mean it still shudders when you step on the brakes(and probably gets worse when they're hotter) and the steering wheel vibrates or wobbles then the wrong end of the car was addressed for the symptoms. you probably needed the front rotors resurfaced or replaced with new pads (i work at a honda dealership we very rarely need to resurface rear rotors other than from severe neglect
  Reply
  Flag This
  Like | 1 person likes this1

• Can head gasket work cause the engine then to crack?
  So if the head gasket work was done and then a week and a half later the car overheats again and then they tell us i...

  Q&A > Honda > 2002 Honda Accord

• 2000 Honda Accord Ex V6 3.0 help>>>>>>>
  Hey guys I have a 2000 Honda Accord lx V6 , and i've been having a problem. Some days when i've driven the car around doing errands, I would get back in my car after leaving it for ten min, and ...

  Q&A > Honda > 2000 Honda Accord

• timing belt change - unexpected oil seals and coolant pipe replacement over charge?
  I have a 1995 Honda Accord Ex sedan 4 cyl manual shift with 297,000 miles on it. I decided to get the timing belt for $550 & tuneup $270 (spark plugs, distributor cap, rotor, air filter) done with...

  Q&A > Honda > 1995 Honda Accord

• my air was working just fine and i decided to give it a little boost with some r
  r134 took 3/4 can then it made some funny noises and the it started smoking now i got no air

  Q&A > Honda > 1999 Honda Accord

• overhead cam repair faulty?
  We had the overhead cam/crankshaft, timing belt replacement kit, water pump, and all drive belts, oil pan gasket replaced at 120,000 miles just to make sure the car remained running strong. After ...

  Q&A > Honda > 1993 Honda Accord