Rookie

Rookie

35 points

More About Points »

Hwy20

Waterloo, AL

HWY20 has not written a profile yet.

Recent Activity

Questions & Answers | Problem Reports | Reviews | Comments

Question Asked: 

my car will not crank. i am told that it is the ecu. my neighbor has a car that is exatly like mine. will the ecu run mmy car?


Flag This
Question Asked: 

I HAVE REPLACED THE IDLE AIR VALVE, TPS, AND WENT THROUGH THE STEPS OUTLINED IN THE MANUAL TO RESET THE IDLE BUT IT STILL DOES NOT ALWAYS IDLE THE SAME. ONE TIME IT WILL IDLE RIGHT THE NEXT TIME IT IDLES TOO FAST, THEN TOO SLOW. SOMETIMES TOO ROUGH. I TRIED TO CLEAN OUT THE THROTTLE PLATES BUT MAY NOT HAVE DONE A GOOD ENOUGH JOB. THANKS THANKS FOR YOUR HELP.


Flag This
Question Asked: 

I HAVE CHECKED FUEL RAIL PRESSURE, IT IS 45 PSI. REPLACED THE ICM- CRANK POSS. SENSOR-PRESSURE REG- MASS AIR FLOW SENSOR,I HAVE CHECKED FOR SIGNAL TO INJECTOR AND THERE IS NONE. I WOULD LIKE TO BYPASS THE PASS-KEY SYSTEM BEFORE I REPLACE THE PCM. HOW CAN I DO THIS? THANKS


Flag This
Question Asked: 

FUEL RAIL PRESSURE IS AT 45 PSI-HAVE CHANGED ICM,CRANK POS SENSOR, PRESSURE REG, MASS FLOW SENSOR. THE ONLY CODE STORED WAS FOR THE O2 SENSOR. NO OTHER CODE STORED. I SUSPECT THE PCM,BUT DON'T KNOW PROPER PROCEDURE TO CHANGE IT. PLEASE HELP AND THANKS!


Flag This
Answer Ranks