Enthusiast

Enthusiast

50 points

More About Points »

Paul Chop

Cape May, NJ

Paul Chop has not written a profile yet.

Recent Activity

Questions & Answers | Problem Reports | Reviews | Comments

Question Asked: 

I had the face plate replaced. Now the air only comes on when I have the fan switch on #4, but even then after a while it turns off and I have to turn it back on.


Flag This
Question Asked: 

I had starter replaced today. After which it was hard to start and keep running. It ran smoother with the faulty starter. The guy who put it in said, 'it was'nt anything i did'. It had to be something he did, or did'nt do!! any advice?


Flag This
Question Asked: 

Today, I had the starter replaced. Even with the old one the vehicle would start quickly and run smooth, although I knew it was on its last legs. Now that I replaced it, it is harder to start. The guy that replaced it says, 'its nothing that I did'. I almost feel like putting the old one back on.


Flag This
Question Asked: 

So far I replaced the gas cap, the selenoid and the charcoal cannister. Still, I can't pass inspection because of the cel, can someone supply me with another remedy?


Flag This
Question Asked: 

I have experienced this before but the light was steady. Now it is blinking and the Jeep was shaking. I know I need a new starter, could this be the cause or something additional?


Flag This
Question Asked: 

recently purchased with 36,000 miles. took it to shop who replaced evap vent selonoid and told me to drive for 80 miles which i did last nite, however the light is still on , any advice?


Flag This
Question Asked: 

I took it to shop who replaced the evap vent selonoid (whatever that is), he then told me to drive it for 80 miles which I did last nite. The light is still on. Any ideas?


Flag This
Question Asked: 

The yellow engine light is on. Normally each time I get the oil changed I have the service man reset it. After about 15 or 20thousand miles it comes on again. He told me not to worry since it is a recall problem, probably with the 3rd cylinder recall. However I would like to reset it myself, how do I do it? P.S. The recall has been taken care of on my vehicle.


Flag This
Question Asked: 

fan will only operate on highest speed, was told it may be resistor. where is resistor located? should i replace blower motor while i'm at it?


Flag This
Question Asked: 

I have approx. 107,000 miles on my Jeep. I purchased it used with 65,000 miles. My question is should I have the trans. fluid changed? Some people tell me not to mess with it cause it may start problems.........


Flag This
Answer Ranks