Your Mobile Technician.com

Technician
179 points
YMT is owned and operated by the best in the business of automotive service excellence. We are certified in several different areas of automotive service and detail. So you can feel safe knowing that your business or personal investments are in good hands. We offer several different ways that YMT can service your needs
Recent Activity

Question Answered: my car is jerking going down the road?
December 03, 2010, 08:05 PM
Could be several different problems. ING. Trans. Fuel.......How often does it happen, is it when its cold or hot, or going up hill, under a load?
Question Answered: Air Conditioning issue
August 25, 2010, 09:28 PM
You lost the vacume to the controle unit. It a black or grey vacume line going from the firewall to the intake manifold is where they break most of the time. Check that first.
Question Answered: Car Lighter Fuse
August 25, 2010, 09:25 PM
Under the dash. should be in a small fuse box drivers side
Question Answered: What causes our new belts to break after about 2 weeks?
August 25, 2010, 09:24 PM
Sounds like you have a pully out of alignment. Puts belt at a angle. Or poss. (but not often) tensioner keeping belt to tight.
Question Answered: rear brake service cost
August 25, 2010, 09:20 PM
Depends on hour rates. We are $70 per hour..dealers here are $90 and up
Question Answered: Clicking Sound Under Dash
August 25, 2010, 09:19 PM
Move the air from hot to cold see if it makes the noise. Might be the plastic gears of the blend door motor. I Hope not because that takes a good bit of labor to do that job.
Question Answered: no power to A/C
August 25, 2010, 09:15 PM
There are deff. some fuses Ck under dash and fuse box under hood. Just ck all of them if you do not have the owners manual. You can also google fuse locations
Question Answered: 1991 Ford F150 idles verry ruff and dies whenn put in D or R
August 25, 2010, 09:10 PM
Depending on engine, most fords have Idle Air Controle valves. They go bad all the time. Take something and tap on it while the truck is at idle, then try to put it into gear. You can also pull it off and clean it out with carb. cleaner but that is not a final fix.
Question Answered: Getting a P0401 code EGR flow is insufficeint
August 19, 2010, 06:10 PM
Yes, the DPFE sen. or the EGR ports under the intake are also known for getting stopped up.
Question Answered: no heat
August 19, 2010, 06:08 PM
plastic gear wears out,"blend door actuator" needs to be replaced or the blendoor is broke
No activities found
No activities found
No activities found
Your Mobile Technician.Com's Shops

Answer Ranks