GetrDone

Journeyman
558 points
I collect and build Muscle cars as a hobby and a way to pay college tuition. Currently I have a 1963 Corvette split window #1 condition, 1966 427 Corvette coupe w/sidepipes Survivor, 1974 Pontiac Trans Am 455 #2 condition, !970 Dodge Charger 500 w/440 six pac in the paint shop and a 1965 Chevy Malibu 427 Tunnel Ram in line for the works
Recent Activity

Question Answered: Oxygen sensors
March 01, 2010, 10:01 PM
Usually located before and after the catalytic converter(s) and always use the same brand that came stock with the vehicle
Question Answered: Klunking noise
March 01, 2010, 09:56 PM
Hard to say what is clunking but only 2 things I can think of (CV Axle shafts) or (Motor Mount) but you need to have a shop check this before it dose further damage, you can find a shop here www.repairpal.com/directory
Question Answered: Vibration Damper
March 01, 2010, 09:38 PM
Any bearing located in the alternator, belt tensioner etc could be making the squeaking noise and the harmonic balancer pulley probably isn't loose but bring your vehicle to a repair shop to trouble shoot this noise, you can find one here www.repairpal.com/directory
Question Answered: power stering
March 01, 2010, 09:32 PM
First thing is to have the power steering fluid level checked and the condition of the drive belt that powers the power steering pump, You can find a Repair Shop at www.repairpal.com/directory and they can check these items for you
Question Answered: Main things to be done at 30,000 milese service
March 01, 2010, 09:28 PM
(1) Air Filter (2) Oil Change (3) Transmission Fluid and Filter change (4) Tire Rotation (5) Brake Check This should run about $200 to $250
Question Answered: how do i bleed the clutch?
March 01, 2010, 09:18 PM
This is from www.autozone.com and it sounds like bleeding this setup can be tough to bleed so maybe pre filling the line and slave cylinder before installation or purchase a complete unit On the 2.2L engine, individual components of the clutch actuating system (master cylinder/slave cylinder) may not be available for service. If so it is recommended that a complete, pre-filled and pre-bled unit should be installed and NO attempts should be made to disconnect the hydraulic lines. To expedite the hydraulic clutch bleeding, loose as little fluid as possible when disconnecting hydraulic lines. All openings should be immediately capped or plugged to prevent system contamination or excessive fluid loss.
Question Answered: where is the blower resistor located
March 01, 2010, 04:35 PM
Should be on the firewall side on or next to the blower motor
Question Answered: ENVOY OIL BURNING
March 01, 2010, 04:34 PM
What kind of oil and what weight oil are you running
Question Answered: What type of oil
March 01, 2010, 04:31 PM
Synthetic 5w-30 or 10w-30 Mobile 1 available at Walmart in 5 quart jugs
Question Answered: Removing tail light lens to replace turning signal bulb
March 01, 2010, 04:28 PM
Has to have some screws holding it in from the under side or in the bed
No activities found
No activities found
No activities found
Answer Ranks