Rookie

Rookie

45 points

More About Points »

Ronnie4

Mesquite, TX

ronnie4 has not written a profile yet.

Recent Activity

Questions & Answers | Problem Reports | Reviews | Comments

Question Asked: 

i have a 98 ford escort and it is not fireing on the number 1 cyclinder and the number 4 both cyclinders are not fireing and i have replace the coil pack and i have replace all 4 fuel inj. could someone please tell me what my problem could be . thanks please help


Flag This
Question Asked: 

and the code that it is showing is 1494 could someone tell me what i need to do


Flag This
Question Asked: 

could someone please help me with this problem this car will not start it has no power on the inside of the car it will turn over but it will not start iam not sure if this car has a arla on it or not


Flag This
Question Asked: 

can someone tell me how long does it take for the compter to reset its telling me that the 02heater and just the 02 sen. is not complete and the truck wont pass state insp. untill they read complete


Flag This
Question Asked: 

i got a 1997 dodge ram p-u and iam trying to get the polit bushing out could someone tell me the best way to get out that old bushing so i can put a new one in thanks


Flag This
Question Asked: 

H E L P I have got a 97 ram pu and iam trying to get it inspetdion sticker on it but it wont pass decause the engine light comes on abd the code ix po300 wich bis radmon cylinder misfire well i replace the wires and plugs and it is etill doing the samething someone please help me


Flag This
Question Asked: 

I HAVE A 1997 AND A 2000 DODGE RAM PICKUP And on both trucks the heaters will not blow hot air i have check the water flow and its good and i have replace the thermoast and now iam at the point i just cant figure it out could someone please help me out .


Flag This
Question Asked: 

I hope someone can tell me what causes fuel to be in my oil I have just put this motor in this truck well i have been trying to start this engine for a couple of days now well i took the oil filter off and the oil was gas so i took the oil pan bolt out and the oil was as thin as gas and it even smell like gas so what would been my problem please help i


Flag This
Question Asked: 

I hope someone can tell me the answer that iam looking for i replace the motor with a used motor i think its a 5.2 witch is a 318 i went too the aut parts store and they tell me that engine does not need a camshaft position sen


Flag This
Question Asked: 

@@@@@@@@@@@@@HELP HELP @@@@@@@@@@@ I HAVE A 2001 IMPALA AND THE SERCITY SYSTEM IS GOT IT SO IT WILL NOT SIART AND YES I HAVE GOT A SCAN TOOL BUT ITS NOT GIVEING ME NO CODES SO PLEASE SOMEONE TELL ME WHAT TO DO THE RADIO IS SHOWING CAL ERR


Flag This
Answer Ranks