62 points
Recent Activity

Question Answered: can you fix this problem for me or refer someone or somewhere to fix this
April 21, 2016, 10:18 AM
Get a smoke test to locate leaky intake or exhaust lines.
Question Asked: view car notes stop working Why??
April 21, 2016, 10:07 AM
I want to add info to (view car notes) the info will not save. why??
Question Answered: repair cost to replace lower control arm with ball joint, r and r F control arm lower, both
January 13, 2016, 11:14 AM
$800.00 both sides ( lower)
Question Asked: 2000 honda accord LX 2.3 L cranks no start
July 05, 2015, 12:59 PM
Question Answered: AC squeals
May 21, 2012, 11:35 AM
Mind did the same thing an I was told It was something Major but as it turned out My drive belt was slipping changed the drive belt and adjusted the Hydraulic belt tensioner and the can sounded smooth and quiet.
Question Asked: I have oil all over the front of my 1.8 liter engine ruining my drive belts?
May 21, 2012, 10:22 AM
At this point I have replaced several Drive Belts oil is at the timing cover outside and is seeping out from an unknown area does anyone know how to stop this type of oil leak. Weird thing no drips on the ground. Thanks to anyone that can advise me.
Question Answered: what is correct atf fluid
December 18, 2011, 12:13 PM
The Correct Fluid for your German Made car Is Pentosin ATF 1. Made specifically for your car and lasted a long time between service intervals changes other fluids work but not as good. Electronic components such as Converter Clutches really respond to the Synthetic properties Of Pentosin ATF 1 No. A 0019892203. Info from My Mechanic In Germany. P.S. Can be purchased at your Local Parts house.
Problem Reported: AC Blower May Only Work on High or Melt Connector at Blower
May 27, 2010, 11:08 AM

Failure in the blower motor power module (automatic temperature controls) or resistor block (manual AC) may cause the heater blower motor to work only on the high setting. The connector to the power module/resistor block is known to overheat (and sometimes melt). The connector or terminals should be replaced; a replacement connector is available.

Problem Reported: Temperature Blend/Recirculation Doors May Fail and Cause AC Problems
May 27, 2010, 11:08 AM

Temperature blend and recirculation doors commonly fail, which can cause the AC modes not to change or the temperature to be different on the left and right sides. If replacing blend air doors, a recirculation door, a door link, or a sub-assembly housing, new heating, ventilation and AC (HVAC) sub-assemblies are available that improve reliability.

Car Review: 1997 Mercury Cougar
March 22, 2009, 06:04 PM
This vehicle Is a bit older but Its very roomy, Comfortable,And Its an affortable car to own you won't have to take out a loan to get a water pump replaced.
No activities found
Answer Ranks