hammer29

Rookie
35 points
Recent Activity

Question Asked: when putting on new tires what psi should I put in?
January 20, 2014, 09:02 AM
do I use the tires recommended psi or the sticker on the door?
Question Asked: why does ac warm up under acceleration?
October 23, 2013, 12:04 PM
installed new compressor, condenser and dryer and vacuumed down system for 30 minutes. the gauges are showing good numbers. the air is ice cold when idleing but when given a little throttle it warms up. any help would be greatly appreciated. thank you
Question Asked: the steering wheel and brake pedal are locked and will not function, how do Ifix
October 04, 2013, 07:23 AM
when car was shut off went to restart and steering wheel is locked and the brake pedal is also locked. how do I fix
Question Asked: starter issues
March 30, 2013, 10:13 AM
when i hook the battery up and turn the key on to the RUN position the starter engages. had starter tested is fine. installed new ignition switch still the same. what could be causing this?
Question Asked: how do you set the timing for a 4.3 litre v-6
September 24, 2011, 04:41 PM
how do you find top dead center to set the timing on a 4.3 v-6
Question Asked: Is there enough room to remove the distributor when changing the intake gasket?
September 24, 2011, 03:21 PM
intake gasket removal and reinstallation
Question Asked: fuel pressures
November 18, 2010, 12:49 PM
is there different fuel pressure settings for an s-10 4.3 and an astro van 4.3?
Question Asked: ignition issues
November 17, 2010, 06:01 AM
I have an s-10 that runs for about 5-10 seconds and then shuts off. I have checked the fuel pressure and it is at about 50 pounds so I know its not fuel. could it be the ignition module or something electrical?
Question Asked: 350 turbo transmission
November 12, 2010, 10:13 AM
I would like to adjust the shift points to a higher rpm on my 350 turbo. how do I agjust the vacuum modulator. do I adjust the screw in or out?
Question Asked: fuel pressure regulator
November 12, 2010, 07:47 AM
does the fuel pressure regulator that is located under upper intake assembly get its vacuum from the mainifold pressure or vacuum?
No activities found
No activities found
No activities found
Answer Ranks