43 points
Recent Activity

Question Asked: How difficult is it to change exhaust manifold bolt?
July 17, 2014, 07:27 AM
Broken bolt and leaks in exhaust manifold
Question Answered: AC fan on but not blowing hard through vents.
July 17, 2014, 07:24 AM
Drop the fan under the glove box reach up and you will find a broken door pull it out, it will work great after that. Common problem.
Question Answered: engine oil pressure drops
July 17, 2014, 07:22 AM
Oil sludge in pan is blocking the oil screen and pick up. Problem with the 4.7L
Question Answered: Why would your car not start if you changed the camshaft censor.
July 17, 2014, 07:21 AM
Sometimes the shop will get a code for the cam sensor, but its actually the crank sensor that is bad. Have them both changed.
Question Answered: The oil gauge will suddenly drop then bounce back, the ck gauges light comes on
July 17, 2014, 07:19 AM
I had his issue, with mine we didn't drive the truck much and it developed an oil sludge problem. The sludge was in the oil pan and while the truck was under load, the sludge would temp. block the oil pick up which would cause low oil pressure, then cause the engine check light. We dropped the oil pan and cleaned the pan, screen and pick up tube, also changed oil. Been running good after that.
Problem Reported: Cam Sensor Failure Causing no Start or Stalling
September 15, 2010, 10:08 PM

On the 3.7L V6 and 4.7L V8 the camshaft position sensor may fail and cause the engine to crank but not start or it can cause intermittent stalling. A failed camshaft sensor will require replacement.

Problem Reported: Exhaust Manifold Bolts May Break
May 27, 2010, 11:09 AM

On the 3.7L V6 and 4.7L V8 the Exhaust manifold bolts commonly break, exhaust manifold gaskets should be replaced and replace bolts as needed.

No activities found
No activities found
Answer Ranks