49 points
Recent Activity

Question Answered: 1991 firebird wont start back up.
May 08, 2013, 10:53 AM
Is the security light on?
Question Answered: Have a 01 park ave base- has a code of p 0102 - Mass air flow- . Checked cod
May 08, 2013, 10:47 AM
Unplug the maas air flow sensor and see if problem goes away.
Question Answered: while driving engine died
May 08, 2013, 10:45 AM
Check fuel pressure with a fuel pressure guage.
Question Answered: car is overheating while idling and moving?is it the Thermostsat or water pump?
May 08, 2013, 10:44 AM
Sounds like you have an air pocket in the cooling system. Let it run with the cap off and fill coolant. Make sure the cooling fans are working.
Question Answered: Is it possible to damage a pitman arm, idler arm or idler arm bracket while four
May 08, 2013, 10:42 AM
The steering linkage does not come off when replacing a transmision. What is the issue your having?
Question Answered: Hydroboost brake and steering problems on a 2005 suburban
May 08, 2013, 10:39 AM
Sounds like you hydrobooster is leaking. It is assisted by the power steering pump. See if the ps fluid is low. The hydrobooster usually leaks right where it bolts on to the master cylinder.
Question Answered: Rear rattle when driving over bumps, it stops if I'm applying the brakes - HELP!
May 08, 2013, 10:33 AM
Sounds like a loose brake pad or brake pad retainer.
Question Answered: what causes missing out and the smell of overfueling on and off
May 08, 2013, 10:31 AM
Sounds like a leaking fuel pressure regulator. Moniter with a fuel pressure guage and see if it holds pressure after key is turned off.
Question Answered: My passenger side electric seat is stuck in recline (all the way down) .
May 08, 2013, 10:28 AM
Sounds like a bad tilt motor. See if it has power. Can you hear it trying to work? See if tilt motor is sold seperately.
Question Answered: how do I troubleshoot my1994 3/4 ton vandura conversion van's brake light proble
May 08, 2013, 10:26 AM
First check your brake fuse for open. If o.k. then check your brake switch's power and ground circuits. If they are o.k. make sure the brake switch is adjusted properly. If no power out of brake switch it is probably a bad brake switch. If you have power out of the brake switch, make sure the bulbs and sockets are good and check the circuit from the brake switch to the brake lights.
No activities found
No activities found
No activities found
Answer Ranks