More About Points »
Las Vegas, NV
get fuel pressure test.check fuel pump maybe failing, check fuel pressure regulator for leak and the gas cap.
code P0133 may mean that one or more of the following has happened:The oxygen sensor is faulty,The wiring to the sensor is broken / frayed,There is an exhaust leak.Check everything again, the problem is more than likely the front Bank 1 oxygen sensor. You will likely wind up replacing it also.
check battery and the starter.
This indicates that a problem was detected in the camshaft position sensor circuit. Since it says circuit, that means the problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. Don't just replace the CPS (camshaft position sensor) and think that will definitely fix it.I hope this will help you.
first check your door switch maybe one is broken, they are small like black rubber when you close the door they function as door switch to turn off the light inside.if you just want the light to go off remove the fuse.
water pump alone is ok,you should replaced it both last year so you don't have to go back to replace the water pump when its failing now
i would check and resurface front brake rotors
just bring it to the expert than damaging your door panel, if you can't figure out how to remove the screws and fastener that hold your door panel.
first you should take the wire and plug one by one if your are not sure then have instruction book manual. what size engine 3.8L V6?
under dashboard passenger side