3_Moon

Enthusiast
92 points
Recent Activity

Question Answered: How to replace cabin air filter in 2008 Honda CRV
December 26, 2009, 07:22 PM
Hi Jim, Here are the instructions for your CRV cabin filter replacement: http://www.filters-now.com/pdfs/micronAir/HN03104P.pdf
Question Answered: 02 senson
December 26, 2009, 07:20 PM
Be careful with this diagnostic approach, a fault code is just a piece of information used to help you diagnose the problem, and replacing a part without a proper diagnosis is asking for trouble. If you post the code, we can provide some info that may help avoid replacing unneeded parts. If you do replace the part, I suggest using only OE parts. O2 sensors are tuned specifically for each engine, so using any aftermarket sensors may cause the check engine light to come on again.
Question Answered: what causes gas gage to not register tank contents?
December 26, 2009, 07:10 PM
It really depends on the problem. It can be the fuel gauge sending unit, fuel gauge, wiring or another electrical issue. You'll need to have teh problem diagnosed, which should be about 1 hour of labor (for diagnosis)
Question Answered: Heater/AC fan not working
December 26, 2009, 07:08 PM
I believe the fuse is in the engine compartment fuse box. Look at the cover of the fuse box, it will have a diagram of the fuses.
Question Answered: PCV Location
December 26, 2009, 03:32 PM
I imagine dandd didn't perform a check of your financial situation first before recommending spending $25 on picking up a technical repair manual for your vehicle, which is very helpful advice to anyone performing repairs on their own vehicle. Someone takes their own time to give you advice, and that is the response you give? You are soooooo ungrateful!
Question Answered: malfunction indicator lamp
December 26, 2009, 10:05 AM
Check all your bulbs, one of them may be burned out. If you do replace one, make sure to use the exact same bulb type.
Question Answered: check engine light
July 18, 2009, 01:55 PM
Aloha, If the check engine light is on, there is a fault code(s) stored that will help in determining what the problem is. These codes will need to be checked and then diagnosed, and you are better off taking it to an experienced repair shop for this type of repair.
Question Answered: replacing shocks
July 18, 2009, 01:52 PM
If you are going to take on a job like this, get a repair manual and read the repair instructions, figure out what tools and parts you will need, then if you have specific questions, post them.
Question Answered: alternator belt
July 18, 2009, 01:51 PM
If you are going to take on a job like this, get a repair manual and read the repair instructions, figure out what tools and parts you will need, then if you have specific questions, post them.
Question Answered: water pump
July 18, 2009, 01:50 PM
If you are going to take on a job like this, get a repair manual and read the repair instructions, figure out what tools and parts you will need, then if you have specific questions, post them.
No activities found
No activities found
No activities found
Answer Ranks