nazier

Technician
121 points
My name is nazier I am the owner of E&A Auto Repair and A S E tech
Recent Activity

Question Answered: Squeek frame/springs
April 03, 2011, 03:43 PM
some time you get a rust or dust in the ball joint can make that or lose bolts
Question Answered: heater fan
April 03, 2011, 03:41 PM
if you have manual claimet control you may have vacum line from the engine problem or if its digital you may have bad cotrol or bend door motor good luck
Question Answered: why would a fuel pump make a noticeable noise?
April 03, 2011, 03:37 PM
some time if you have bad fuel filter it can couse that or if you run out of gas before it may weakend the pump
Question Answered: wiring diagram
April 03, 2011, 03:34 PM
did you lost only the tail light or the brake and signal as well you going to a turn signal switch on the steering
Question Answered: Loss of power and shuttering
April 03, 2011, 03:26 PM
1 you may have bad fuel filter or2 you need to check your spark plugs and wire or if your Mil light comes on its need to be scanned for codes and check fuel p/s it will do that if your timing belt is old and jump timing but not likely
Question Answered: engine not starting after headgasket r&r
March 29, 2011, 06:16 PM
you need to make sure you have good timing first and your valve clearnce is good meaning you did not mix the valve lifter and lost the clearance for you valve and check your cam and crank sensor too good luck
Question Answered: Wheel bearings ?
March 29, 2011, 06:00 PM
first you need to check you wheel balance and after that you need to check the state of your tires, bad wheel bearing will make noise or too mutch air in the tires and damage the tier belt in side if your tire is too old but that is very smal chance but i will still check it and road test it wheel bearing dose not have any thing to do with 76000 miles
Question Answered: Air filters
March 29, 2011, 05:48 PM
remove the whole air filter and turn it up side down take the scrows to split the air box to two and you will see the two filter
Question Answered: Lower Control Arm Bushings
March 29, 2011, 05:40 PM
you are not going to see labor for control arm bushings only, because in order to replace the bushing you have to remove the control arm and the bushing will be extra less than 30 m charge Thank you
Question Answered: overheating
March 29, 2011, 03:30 PM
hello Dear first you need to make sure the radiator is full of coolent and check your fuse and realay but you may have a problem with the fan switch or CTS coolent temp sensor
No activities found
No activities found
No activities found
Nazier's Shops

Answer Ranks