Question Answered: how to install timing belt
March 06, 2013, 07:17 PM
As for timing belt not wrong good tooth said, should say installation timing belt, to ensure the two timing pulley (coupling crankshaft and camshaft) position can't be wrong tooth, and the two wheel in the assembly when the wheel to the mark and established align mark, and then install belt (note belt direction) can.this web maybe help you www.hobd2.com
Question Answered: my 2012 fleetwood motorhome ford v10 keeps losing coolant from bottle.
March 06, 2013, 07:12 PM
Slight leakage is hard to find, sometimes even bigger and large discharge. Such as table there is a heater tank, sometimes slightly leakage is difficult to find sleep. Such as cylinder pad or cylinder internal mild water seepage is hard to find. Or patient slowly find leakage, or that first open, and serious to find, easy to some. The lid of the water changed yet? Sometimes the things slight leakage, a very cheap. Try
this web you can www.hobd2.com
Question Answered: My MB C240 starts then dies what fixes this problem
March 06, 2013, 07:05 PM
No good way to really didn't have slowly will be good I just began to learn to drive a car and you put the throttle DiGaoDian clutch slow point will reduce the number of fire but clutch will wear a little a little than usual
Question Answered: Want to upgrade ML stereo/NAV. Also need to replace pneumatic trunk struts.
March 03, 2013, 09:57 PM
The so-called surround sound, usually, compared with double track stereo sound like refers to the listener surrounded a replay mode. This way, produce heavy Homeric field, in addition to retain the original signal source sense of direction outside, still with produce around feeling and expand feeling (voice from the listener diffusion or reverberation feeling.www.hobd2.com) sound effects.
Question Answered: easiest power flush method
March 03, 2013, 07:32 PM
Power flushing is done at high pressure
Power flushing is done at high flow rates (around 100 liters per minute) but at low pressure. It’s actually done at much lower pressure than sealed systems normally operate under.
Power flushing happens at around 1.0 bar, whereas your system can be pressurized to up to 3.0 bar (not that it should), and normally operates at around 1.5bar.
For open vented systems, the pressures are nearly the same. It's actually a very safe and effective procedure, if done by a professional.
maybe this web can help you .www.hobd2.com
Question Answered: why is my trac light on?
March 03, 2013, 07:29 PM
Check your owner's manual, but most likely, it refers to the open of the traction control system. This may be due to give you wear brake, or you may accidentally hit a switch or button. Good luck
you can skip this web www.hobd2.com
Question Answered: Why does my car run hot when i use my air conditioner?
February 19, 2013, 07:40 PM
Error: open compressor to system warm useful.
See the error will know how to operate.
Compressor run only on refrigeration work refrigerant action, and system not warm.
System warm by engine small tank is also the heater in warm water and into the wind and heat exchange, blow out hot air.
So, your automatic air conditioning winter AC will open, you will turn off.
In addition, there should be a refrigeration system and warm two mode adjustable, you transferred to the system warm case, AC should be won't start.
This is two contradictory condition, and the changes in temperature type as the opposite. Open compressor send warm wind, serious aggravate air conditioning damage and fuel consumption.
maybe this web can help you http://www.hobd2.com