I seem to have the locking problem of another member on this Q/A board. Is there another way to unlock the trunk other than the key or power lock button on the inside?
Chrysler Q&AAsk Your Question
2004 Chrysler Crossfire Question: Unlocking Trunk
Answer #1Rocknrollgypsy March 04, 2010, 05:21Rookie
Trunk won't open. Is there another way to get it open other than the latch? There is no key hole on the trunk and there isn't a power button. Help!
The car is a Chrysler Crossfire 2005.
ReplyVisitor, April 19, 2011, 15:19
Answer #2Visitor, April 27, 2010, 18:43
2005 crossfire: The trunk latch isn't working... I got in through convertible top to get my bags... but how do I open the trunk?
Answer #3Visitor, April 30, 2010, 08:56
same problem... took my car into body shop- there were some small plastic pieces broken...
Answer #4Visitor, May 06, 2010, 10:07
Thanks! Indeed, I have the same problem. I took the car to body shop- small plastic pieces broken. Took 3 days to get them in stock, and then they broke them trying to put them in. Back on order....
Answer #5Visitor, July 24, 2010, 12:06
The only way to open your trunk is you need to remove you licence plate bulb cover with bulb assembly on the Right side of the car.
Then you stick your finger in the small opening and Try then to feel around and find the latch lever and push it up. This is hard to do and you need have good coordination with your finger, Because it can be Hard and frustrating. Good Luck other wise you need to take it to good Five Star Chrysler Dealership because very few technician went to the Crossfire Training and Good one are hard to find.
Chrysler Crossfire Technician
Tucson Chrysler Jeep
ReplyVisitor, April 19, 2011, 15:04
wrong answer Buddy, There are no holes only drain holes
DO NOT LISTEN TO THIS GUY i have done this and there is no lever or latch assambly to push or pull----Good luck buy Jap!
Replyelisp, December 25, 2012, 10:23Rookie
Right Answer! I have done this twice and both times have gone to this post. The mistake he made is it is the left side of the light bulb cover that you remove and in 3 seconds you will be able to push the button in towards the center and it will be fixed. The only thing you may need is glue to seal the light bulb casing back to the hatch back. Mine came off and was fixed with glue.
ReplyRI2004Crossfire, June 18, 2014, 08:54Rookie
Does the button have the yellow hose connected to it? I can't seem to find a button, can you specify where the button is?
Answer #6OneSicSRT March 03, 2012, 15:24Rookie
2004 Crossfire, rear hatch won't lock or unlock. removed all rear hatch panels, after about 45 minutes of hearing a vacuum leak I found the broken vacuum hose in the elbow in the upper right hand wire loom where it makes the bend from the hatch to the body of the vehicle. The yellow vacuum hose was actually broken completely apart. re-attached with rubber hose, works fine now.