GMC Yukon Denali Problem Report

GMC Yukon Denali Clicking Noise From Flasher When Turn Signals are Off

(11 reports)

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

The turn signal SOUND or NOISE is constantly will not stop. It is constantly on even though the turn signal is not in either left or right position. -
Replaced turn signal switch -
There is a clicking sound that comes from the dash even when the turn signal is off what is that? -
non- Denali, but same issue. turn signal clicking noise is constant, even though the turn signals are not on -
Related Items:
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the...
The steering may develop a clunk type noise from the upper intermediate steering shaft.  O...
my light on the doors stays on after the vehicle is turned off.
One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail,...