Q&A

1996 Chrysler Concorde

Question: Transmission not shifting

Question

J_Krajewski2, 3.3L V6, Flat Rock, MI, April 21, 2009, 17:26

 Rookie

My 96 concorde was driving fine and then suddenly started to go in and out of gear and then not shift all together and after replacing the wiring harness and compuetr for the trans it still doesn't want to stay in gear or shift and heres the icing on the cake now you hear the torque converter squeling when it does go into gear

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  Bret Bodas May 02, 2009, 09:30
  

   Master

  Did a shop diagnose and replace the wiring harness and computer for the transmission problem?
  Reply
  Flag This
  Like0

• Transmission not engaging and slips
  Initially transmission would not engage when under 1000 rpm, but then would instantly engage, jerking the car. Tod...

  Q&A > Chrysler > 2001 Chrysler Concorde

• transmission module bad
  Is it hard to fix or repair? My tanny will run fine for a while then it wont shift into overdrive unless i turn the car off and start it back up again and it will run fine for a while longer. What ...

  Q&A > Chrysler > 2004 Chrysler Concorde

• shifting
  my car doesnt shift while driving its like it is stuck in 2nd when im going 40 miles an hour my rpms are between 4 and 4 and a half what could this be

  Q&A > Chrysler > 1994 Chrysler Concorde

• Automatic Transmission May Have Shifting Issues/Noise While in Reverse
  The automatic transmission can develop problems like harsh shifting, shuddering between shifts, and a buzzing while in Reverse. Repairs for many of these problems are outlined in service bulletins ...

  Common Problems > Chrysler Concorde

• transmition
  My concord recently has started having shifting problems , when driving if i exceed 40 miles per hr and the have to come to a stop and restart the car will not shift into the overdrive gear and I a...

  Q&A > Chrysler > 2000 Chrysler Concorde