Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
Toyota Sequoia Recalls
This limited regional recall is for vehicles currently registered or first sold in southern Florida, along the Gulf Coast, Puerto Rico, Hawaii, the U.S. Virgin Islands, Guam, Saipan and American Samoa. Upon deployment the passenger airbag inflator could rupture, increasing the risk of personal injury. Dealers will replace the passenger side air bag inflator to correct this concern. If a replacement inflator is not available, as an interim measure, the dealer will disable the front passenger air bag and advise the customer not to use the front passenger seat until a replacement inflator is installed.
This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. Dealers will replace the affected airbag inflator modules to correct this concern.
When deployed, excessive pressure can build in the passenger front airbag. This could cause the inflator to rupture, increasing the risk of personal injury to vehicle occupants. This recall affects both originally installed passenger front airbags as well as those that were installed as replacement service parts. Toyota and General Motors will replace the passenger front airbag inflator on their respective vehicles involved in this recall.
Airbags use a chemical reaction contained in an inflator module to create the pressure necessary to inflate the bags when deployment is required. These vehicles are being recalled because the front passenger airbag inflator may produce excessive internal pressure when deployed. As a result, the inflator module could rupture, causing metal fragments to strike vehicle occupants. Dealers will inspect and replace any defective passenger front airbag inflator module found.
Vehicles have a tire size/weight rating label to inform owners of the carrying capacity of their vehicle. These models are being recalled because the incorrect vehicle weight rating is shown on the information label. This could result in vehicle and tire overloading, increasing the risk of tire failure. Owners will be provided an updated vehicle weight label to correct this concern.
Toyota and General Motors are recalling certain models because the power window master switch assembly in some of these vehicles was built using a less precise process for lubricating the internal components of the switch assembly. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat. This could result in the switch melting or possibly catching fire. Dealers will inspect and repair or replace the master window switch as necessary.
Due to a calibration error, the tire pressure monitoring system warning light may not illuminate to warn of incorrect tire pressure. Driving with the incorrect tire pressure can result in tire failure, increasing the risk of a crash. Dealers will re-initialize the tire pressure monitoring system to restore proper operation. Toyota has not provided a notification schedule at this time.
The center position of the steering angle sensor (SAS) may not be stored correctly due to improper logic of the skid control ECU programming. The vehicle stability control (VSC) system could activate at a low speed for a few seconds during acceleration from a stopped position. Should this occur, the vehicle may not accelerate as quickly as the driver expects, increasing the risk of a crash. Dealers will update the ECU software or replace the module as necessary. This recall began on June 11, 2010. The Toyota recall number is AOG.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.