» »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

Toyota Echo recalls

 

For Models: Toyota Echo, Toyota Prius

Engine, July 26, 2006

Summary: ON CERTAIN PASSENGER VEHICLES, DUE TO IMPROPER MOLDING OF THE RESIN BODY OF THE CRANKSHAFT POSITION SENOR INSTALLED ON THE ENGINE BLOCK, ENGINE OIL MAY PENETRATE THE SEAL AND ENTER THE SENSOR WIRING CONNECTOR. THE WIRE HARNESS CONNECTOR MAY NOT BE SUFFICIENTLY ATTACHED TO THE LOCKING TAB OF THE SENSOR WIRING CONNECTOR.

For Models: Toyota Celica, Toyota Echo

Brakes, November 29, 2004

Summary: CERTAIN PASSENGER VEHICLES HAVE THE POSSIBILITY THAT THE RECESS RETAINS A RUBBER SEAL RING, WHICH IS LOCATED AT THE END OF THE CYLINDER BODY, AND MAY BE CORRODED DUE TO AN IMPROPER WASHING PROCESS.

For Models: Toyota Echo

Brakes, November 9, 2002

Summary: ON CERTAIN PASSENGER VEHICLES, IF THE VEHICLE IS DRIVEN UNDER REPEATED START AND STOP OPERATION IN LOW AMBIENT TEMPERATURES AND IN DEEP SNOW, THERE IS A POSSIBILITY THAT SNOW COULD ACCUMULATE IN LARGE QUANTITIES INSIDE THE REAR WHEEL AND FREEZE. THE SNOW FROZEN INSIDE THE WHEEL COULD CONTACT THE REAR BRAKE LINE DURING WHEEL ROTATION.

For Models: Toyota Echo

Brakes, October 29, 2001

Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AN AUTOMATIC TRANSMISSION. DUE TO A UNIQUE COMBINATION OF CONDITIONS WHICH CONSIST OF COLD AMBIENT TEMPERATURES, LOAD APPLIED FROM AIR CONDITIONER AND OTHER ELECTRICAL DEVICES, AND IMMEDIATELY AFTER STARTING THE ENGINE, THERE IS A POSSIBILITY THAT THE VACUUM IN THE INTAKE MANIFOLD COULD BE INSUFFICIENT FOR THE BRAKE BOOSTER.

For Models: Toyota Echo

Engine, October 4, 2000

Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF ALASKA, COLORADO, IDAHO, ILLINOIS, IOWA, KANSAS, MAINE, MICHIGAN, MINNESOTA, MONTANA, NEBRASKA, NEVADA, NEW HAMPSHIRE, NEW YORK, NORTH DAKOTA, SOUTH DAKOTA, VERMONT, WISCONSIN, AND WYOMING. CONDENSED MOISTURE FROM THE POSITIVE CRANKCASE VENTILATION (PCV) PORT COULD SEEP TOWARD THE BRAKE VACUUM PORT INSIDE THE INTAKE MANIFOLD AND START TO FREEZE.