Toyota is recalling 2004 Corollas equipped with factory aluminum alloy wheels. The lug nut(s) may not secure the wheel properly to the hub assembly due to over-drilling of one or more of the five lug nut holes on the alloy wheel. If the vehicle is driven for a long time, the lug nut(s) could loosen or even fracture. This may result in the separation of the wheel from the hub assembly and a loss of vehicle control. Dealers will inspect all four factory aluminum alloy wheels and replace them if necessary.
Toyota Corolla Recalls
Toyota is recalling 2003 Corolla models with VIN numbers starting with 1NX. The bolts that join the rear brake and hub assembly to the rear axle carrier may become loose due to insufficient tightening during the assembly process. Noise or compete separation of the rear brake and hub assembly from the rear axle carrier could occur, leading to a loss of vehicle control. Dealers will properly tighten the bolts.
Toyota is recalling certain 1997 Corollas because a mechanical shock (like moving the seat or suddenly releasing the parking brake) to the air bag computer soon after the engine is started can cause the air bag to deploy inadvertently. This can cause injury to an occupant. Dealers will repair the air bag computer.
Toyota is recalling 1996 T100, Camry, Celica, Corolla, and Tacoma models because the cruise control system may fail to hold the speed set by the driver and can accelerate above the intended set speed. This can increase the risk of a crash. Dealers will replace the cruise control assemblies.
Toyota is recalling 1995 Corolla and Tacoma models for a defective weld inside the positive and/or negative terminal, which may allow the connection inside the terminal to separate. This can result in a no-start condition or the battery could explode. Dealers will replace the defective batteries.
Toyota is recalling 1993-1994 Corolla models because an unused harness connector for power windows, power door locks, and sunroof was improperly routed under the floor carpet in the left kick panel. In cold weather areas where road salt is used, the water from a driver's foot can penetrate the carpet, drop onto the connector, and form a salt bridge between the terminals. This can cause an electrical short, which may result in a fire. Dealers will remove the unused harness connector.
Toyota is recalling 1994 Corolla models because the anchor straps installed in the seat belt assemblies were improperly heat treated. This may cause them to break and not sufficiently restrain occupants in the event of a sudden stop or crash. Toyota will replace the safety belt anchor straps.
Toyota is recalling 1992 Corolla models due to a computer program error that caused certain digits of the GVWR and the GAWR to appear in incorrect locations on the certification label located on the left front door of the affected vehicles. Dealers will replace the certification labels.