» » »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

2007 Toyota Tundra recalls

 

Electrical & Lights, October 10, 2012

RepairPal Expert Overview:

Toyota and General Motors are recalling certain models because the power window master switch assembly in some of these vehicles was built using a less precise process for lubricating the internal components of the switch assembly. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat. This could result in the switch melting or possibly catching fire. Dealers will inspect and repair or replace the master window switch as necessary.

Learn more »

Suspension & Steering, May 12, 2011

RepairPal Expert Overview:

Southeast Toyota is recalling 1629 vehicles because the tire pressure monitoring system may not have been calibrated correctly. As a result, the low tire pressure warning lamp may not illuminate if tire pressure drops. Operating the vehicle on under-inflated tires can result in tire failure, increasing the risk of a crash. Dealers will recalibrate the system to correct this concern. This recall is expected to begin during May of 2011.

Learn more »

Body, Interior & Misc., May 27, 2010

RepairPal Expert Overview:

These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.

Learn more »

Body, Interior & Misc., May 27, 2010

RepairPal Expert Overview:

Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.

Learn more »

Body, Interior & Misc., February 5, 2010

RepairPal Expert Overview:

Toyota is recalling 2005–2010 Avalon; 2007–2010 Camry, 2009–2010 Corolla, Corolla Matrix, and Rav4; 2010 Highlander; 2008–2010 Sequoia; and 2007–2010 Tundra models because the sliding surface of the friction lever may become smooth during operation, which can cause condensation. This may cause the accelerator pedal to become harder to depress, slower to return, or to become stuck in a partially depressed position, which can increase the risk of a crash. Dealers will install a reinforcement bar in the accelerator pedal so it will operate smoothly.

Learn more »

Body, Interior & Misc., December 31, 2009

RepairPal Expert Overview:

Toyota is recalling 2004–2010 models for an accelerator pedal that can get stuck in the wide open position due to problems with the floor mat. This may cause high vehicle speeds that make it difficult to stop the vehicle, which can result in a crash. In order to correct the problem, dealers will replace the pedals, alter the shape of the floor, and/or replace the floor mats. Toyota will also modify software on certain models to ensure that the brake overrides the accelerator in the event that both are applied.

Learn more »

Body, Interior & Misc., September 18, 2009

RepairPal Expert Overview:

The load carrying capacity modification label may be missing from the vehicle. This information provides maximum load carrying weights as well as information about required tires and wheels. If not present, an inappropriate load may be carried in the vehicle, increasing a safety risk. Toyota has supplied customers with a new label to affix to the vehicle. This recall began on August 18, 2009.

Learn more »

Drive Train, January 7, 2008

RepairPal Expert Overview:

On some 4WD trucks, improper heat treatment of the slip yoke might have caused its hardness to be insufficient. The yoke may break, causing the drive shaft to separate at the joint and contact the road or the fuel tank, which could result in a loss in vehicle control or a fuel leak. Dealers will inspect the slip yoke and replace the propeller shaft free of charge. The recall began January 7, 2008. The Toyota recall number is 70G.

Learn more »
Ask a Question