2005 Toyota Solara Problems

RepairPal has identified the most common problems with the 2005 Toyota Solara as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
7
Known Problems

The head gasket may fail due to a defect in manufacturing of the cylinder block.

On this vehicle, the head bolts are known to pull the threads out of the engine block, allowing the head to slightly lift, and causing head gasket failure. Symptoms may include:

  • Overheating
  • White smoke from exhaust
  • Rough running conditions and/or inability to start or idle
  • White or cream colored oil on dipstick
  • Check engine light 
  • OBD Trouble Codes P2181, P0300

When the head gasket fails, the bolt holes for the head bolts must be repaired before the cylinder head can be remounted. 

This issue is not always preventable, but to help avoid it, never run the engine if the engine temperature is ever above the normal range. 

Sludge can build up in the engine because Toyota did not recommend frequent enough oil changes. Lexus will sometimes offer a discount on cleaning the engine if necessary. Owners who changed their oil every 3,000 miles did not experience these problems. This sludge build up can lead to excessive oil consumption.

Intermittent failure of a purge control valve in the evaporative emission system can cause the Check Engine Light to illuminate. A failed valve should be replaced to correct this problem.

 

The Check Engine Light may illuminate because a component of the oxygen sensor stops working. As a result the engine computer is unable to determine the proper ratio of air to fuel for the engine. Replacing the failed oxygen sensor should correct this concern.

On higher mileage vehicles, an engine misfire may develop and/or the Check Engine Light may illuminate due to a failed ignition coil. It is not uncommon to replace all the coils when the first one fails in order to prevent return trips to the repair shop.

Debris can get into the idle air control valve. This will restrict the air flow into the engine, causing idle speed and/or stalling when cold. The valve can be cleaned or replaced to correct this concern.