At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes. Be sure to check the condition and runout of the front wheel bearings on the 2WD and 4WD vehicles and the CV joints on the 4WD vehicles since worn wheel bearings and/or CV joints can cause the ABS trigger rings to rub against the ABS sensors and damage them.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1993 Toyota Pickup problems
The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
At higher mileages (125,000+) the mass air flow sensor may cause the vehicle to idle rough, run rich and even stall. Our technicians recommended to replace the mass air flow sensor with a factory unit because the aftermarket units have very mixed results.
If the vehicle will not crank over, the most common problem is the starter, which tend to fail at about 100,00-125,000 miles. Sometimes it is only the starter solenoid contacts, but often the complete starter (including solenoid) needs to be replaced.
On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.
At higher mileages (125,000-150,000) the input shaft seal to the power steering gear may leak. It is recommended to replace the steering gear with a quality rebuilt or new unit rather than attempt to re-seal the original unit.
A loss of power on the freeway may due to an internally leaking fuel pulsation dampener. This commonly occurs on higher mileage vehicles.
The timing chain can develop a rattling noise caused by failing timing chain guides. This is often due to extended mileage intervals between oil changes that allows the oil to become dirty and abrasive which wears away the timing chain guides until they fail. The timing chain and guides should be inspected at each valve adjustment, otherwise serious engine damage may result.
Usually by 150,000 miles the AC system will need some attention, especially in climates where it is used often. Our technicians tell us that it is best to service the AC system every 2-3 years. This keeps the moisture in the system at a minimum which extends the life of the components
The AC Expansion Valve may develop a very slow leak or allow too much refrigerant flow which reduces cooling. Our technicians tell us that Toyota makes an updated expansion valve to resolve these problems if and when they occur.
A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.
At higher mileages (125,000+) the Engine Coolant Temperature Sensor may intermittently stop working, especially when the vehicle is fully warmed up. This can cause the engine to stall unexpectedly.