The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1990 Toyota Pickup problems
If the vehicle will not crank over, the most common problem is the starter, which tend to fail at about 100,00-125,000 miles. Sometimes it is only the starter solenoid contacts, but often the complete starter (including solenoid) needs to be replaced.
At higher mileages (125,000-150,000) the input shaft seal to the power steering gear may leak. It is recommended to replace the steering gear with a quality rebuilt or new unit rather than attempt to re-seal the original unit.
The timing chain can develop a rattling noise caused by failing timing chain guides. This is often due to extended mileage intervals between oil changes that allows the oil to become dirty and abrasive which wears away the timing chain guides until they fail. The timing chain and guides should be inspected at each valve adjustment, otherwise serious engine damage may result.
Usually by 150,000 miles the AC system will need some attention, especially in climates where it is used often. Our technicians tell us that it is best to service the AC system every 2-3 years. This keeps the moisture in the system at a minimum which extends the life of the components
At higher mileages (125,000 -150,000) the power steering pump may begin to leak on the 6 cylinder vehicles and could require replacement.
The Ignition Coil wire insulation is often rubbed through by the Primary wiring harness which will cause a stalling/no-start condition. The coil wire will need to be replaced and the primary harness will need to be repaired and re-routed.