1997 Toyota Paseo Problems

RepairPal has identified the most common problems with the 1997 Toyota Paseo as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.

The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.

The anti-lock brake system (ABS) may function erratically or illuminate the warning light due a damaged wheel speed sensor. A wheel bearing and/or CV joint with excessive runout can cause the ABS trigger rings to rub against the ABS sensors and damage them.

The Evaporative system may have problems with the vapor canister releasing charcoal pellets that plug the vent valve. Typically a Code P0441, P0442 and P0446 will be set. The key code is the P0446 which is a vent valve electrical failure. The proper repair is to replace the entire canister with all the valves as a unit. This is located on top of the fuel tank and is expensive. Our Technicians tell us that for awhile Toyota was covering these problems, but this may have changed. It would not hurt to call the dealer if this problem occurs to see if Toyota is still helping with these repairs.

At 125,000-150,000 miles, the Brake Master Cylinder may need replacing. It is critical to adjust the brake pedal to Master Cylinder pushrod clearance or the brakes will drag and over heat.

The timing belt tensioners may make a rattling noise at a higher mileages. This is due to the adjustment being at its limit. Our technicians tell us that range of the adjuster may be lengthened by elongating the slot where the spring attaches by 2-3 mm to remedy this problem.

A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.

There is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, otherwise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

If the engine will not crank over, the most common problem is the starter. These will tend to go out at about 100,00-125,000 miles. Sometimes it is only the starter solenoid, but often the complete starter (including solenoid) needs to be replaced.

It is important to regularly check the valve clearance as the exhaust valves may become too tight. This will lead to valve failures which are expensive to repair.

Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.

The ignition coil inside the distributor can fail. There will be a hesitation on acceleration, especially when the vehicle is warming up on cold, rainy days. The pickup coil inside the distributor can also fail and cause a no-start condition. There have also been some failures of the radio noise suppressor inside the distributor, which can short out. Our technicians recommend replacing the whole distributor with a complete, genuine Toyota distributor if any of its components fail.

Over the time the exhaust gas recirculation (EGR) system may become plugged with debris, the oxygen sensor may also be getting slow or 'lazy' around this time. When servicing or cleaning  the EGR system, it is a good idea to replace the oxygen sensor because it works in tandem with the EGR system.