The anti-lock brake system (ABS) may function erratically or illuminate the warning light due a damaged wheel speed sensor. A wheel bearing and/or CV joint with excessive runout can cause the ABS trigger rings to rub against the ABS sensors and damage them.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1995 Toyota Paseo problems
The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
The ignition coil inside the distributor can fail. There will be a hesitation on acceleration, especially when the vehicle is warming up on cold, rainy days. The pickup coil inside the distributor can also fail and cause a no-start condition. There have also been some failures of the radio noise suppressor inside the distributor, which can short out. Our technicians recommend replacing the whole distributor with a complete, genuine Toyota distributor if any of its components fail.
If the vehicle will not crank over, the most common problem is the starter, which tend to fail at about 100,00-125,000 miles. Sometimes it is only the starter solenoid contacts, but often the complete starter (including solenoid) needs to be replaced.
On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.
A loss of power on the freeway may due to an internally leaking fuel pulsation dampener. This commonly occurs on higher mileage vehicles.
At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.
A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.
There is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, otherwise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.
At 125,000-150,000 miles, the Brake Master Cylinder may need replacing. It is critical to adjust the brake pedal to Master Cylinder pushrod clearance or the brakes will drag and over heat.
The Throttle Position Sensor can get out of adjustment due to wear in the throttle body or due to carbon build up. This will cause the idle timing to advance more than 30 degrees which will cause very high HC and NOx emissions. Conversely, the Throttle Position Sensors can wear out and not properly advance the timing which causes a lack of power and poor fuel economy.