1992 Toyota Paseo Problems

RepairPal has identified the most common problems with the 1992 Toyota Paseo as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
23
Known Problems

The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.

You may be able to prevent automatic transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned, the transmission system should be completely flushed.

The anti-lock brake system (ABS) may function erratically or illuminate the warning light due a damaged wheel speed sensor. A wheel bearing and/or CV joint with excessive runout can cause the ABS trigger rings to rub against the ABS sensors and damage them.

On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.

The timing belt tensioners may make a rattling noise at a higher mileages. This is due to the adjustment being at its limit. Our technicians tell us that range of the adjuster may be lengthened by elongating the slot where the spring attaches by 2-3 mm to remedy this problem.

The AC Expansion Valve may develop a very slow leak or allow too much refrigerant flow which reduces cooling. Our technicians tell us that Toyota makes an updated expansion valve to resolve these problems if and when they occur.

A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.

Typically the AC compressor is worn out by about 150,000 miles in warm and/or humid climates. It is recommended to replace the complete compressor including a new clutch and rpm sensor, and to replace the receiver/dryer as well.

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

The power steering pump and power steering hoses tend to develop leaks and require replacement.

If the vehicle develops an annoying, clunking sound when driving over bumps it is usually the struts and strut bearing plates. These may need replacing at 100,000-125,000 miles or sooner. If the noise is a more of a squeak or groan, it can be usually be eliminated by spraying a light lubricant on the suspension bushings 1-2 times per year.

If the engine will not crank over, the most common problem is the starter. These will tend to go out at about 100,00-125,000 miles. Sometimes it is only the starter solenoid, but often the complete starter (including solenoid) needs to be replaced.

It is important to regularly check the valve clearance as the exhaust valves may become too tight. This will lead to valve failures which are expensive to repair.

Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.