2010 Toyota Corolla Problems

RepairPal has identified the most common problems with the 2010 Toyota Corolla as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

The Check Engine Light may illuminate due to an evaporative emission (EVAP) system fault. Our technicians tell us these EVAP system faults can be difficult to diagnose but it is not uncommon to find a failed charcoal canister or a loose or worn gas cap.

The mass air flow sensor on higher mileage cars occasionally needs to be cleaned or replaced if sluggish acceleration is experienced or the Check Engine Light is illuminated with a mass air flow meter sensor fault code stored.

The engine mount on the passenger side of the car can wear out on cars with high mileage. This will put extra stress on the other mounts and the faulty mount will need to be replaced.

There are occasional reports of daytime running light problems.

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

The rear Oxygen sensors are a critical element in fuel control (unlike other vehicles) and can cause an emissions test failure for high CO and HCs. The sensing element cracks and and reports an erroneous steady state lean condition which confuses the engine computer.

The bolts attaching the front door window glass to the window regulator may come loose. This can cause the window regulator to become damaged and possibly causing the window glass to break. Some 2003 & 2004 models have been recalled for the issue.

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.