2007 Toyota Camry Problem Reports

RepairPal Verified 2007 Toyota Camry Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes. Be sure to check the condition and runout of the front wheel bearings on the 2WD and 4WD vehicles and the CV joints on the 4WD vehicles since worn wheel bearings and/or CV joints can cause the ABS trigger rings to rub against the ABS sensors and damage them.

The proper repair for a leaking Steering Rack & Pinion is replacement with a new unit.

Intermittent failure of a purge control valve in the evaporative emission system can cause the Check Engine Light to illuminate. A failed valve should be replaced to correct this problem.

 

The valve cover gaskets have a tendency to leak oil, especially the one near the firewall.

Driving over bumps causes loud, annoying noises in the body of the car. If the noise is a groaning or creaking, it can be improved by lubricating the rubber joints in the suspension system. If the noise is a rattling sound, the problem is likely wear and tear on the upper mounting plate for one or more of the suspension struts.

On higher mileage vehicles, an engine misfire may develop and/or the Check Engine Light may illuminate due to a failed ignition coil. It is not uncommon to replace all the coils when the first one fails in order to prevent return trips to the repair shop.

The Check Engine Light may illuminate because a component of the oxygen sensor stops working. As a result the engine computer is unable to determine the proper ratio of air to fuel for the engine. Replacing the failed oxygen sensor should correct this concern.

Cars equipped with an automatic transmission might experience a hesitation when accelerating. Revised software for the on board computer is available which may correct this problem. Software revisions are commonly most helpful on newer vehicles. once the mileage builds up a worn component could cause similar problems. Whenever major transmission work in performed, the transmission software should be updated as necessary.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians tell us this condition is best corrected by replacement of the front rotors and brake pads.

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

The power steering pump and power steering hoses tend to develop leaks, particularly in the V6 models.

One or more motor mounts may wear out on cars with high mileage. This will put extra stress on the other mounts, and the faulty mount(s) should be replaced.

As the size of the Camry vehicle gets ever larger, there is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, otherwise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.

The timing belt tensioners may make a rattling noise at a higher mileages. This is due to the adjustment being at its limit. Our technicians tell us that range of the adjuster may be lengthened by elongating the slot where the spring attaches by 2-3 mm to remedy this problem.