1990 Toyota Camry Problems
RepairPal has identified the most common problems with the 1990 Toyota Camry as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Cars equipped with an automatic transmission might experience a hesitation when accelerating. Revised software for the on board computer is available which may correct this problem. Software revisions are commonly most helpful on newer vehicles. once the mileage builds up a worn component could cause similar problems. Whenever major transmission work in performed, the transmission software should be updated as necessary.
The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
The valve cover gaskets have a tendency to leak oil, especially the one near the firewall.
The ignition coil inside the distributor may fail. Our technicians tell us this may result in a hesitation on acceleration, especially when the vehicle is warming up on cold, rainy days. The pickup coils inside the distributor can also fail and cause a no-start condition. There have also been some failures of the radio noise suppressors inside the distributors, which can short out. Our technicians recommend replacing the whole distributor with a complete, genuine Toyota distributor if any of its components fail.
As the size of the Camry vehicle gets ever larger, there is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, otherwise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.
One or more motor mounts may wear out on cars with high mileage. This will put extra stress on the other mounts, and the faulty mount(s) should be replaced.
If the vehicle will not crank over, the most common problem is the starter, which tend to fail at about 100,00-125,000 miles. Sometimes it is only the starter solenoid contacts, but often the complete starter (including solenoid) needs to be replaced.
The pickup coil inside the distributor can fail and cause a no-start condition. There have also been some failures of the radio noise suppressors inside the distributor which can short out. It is recommended to replace the whole distributor with a complete genuine Toyota distributor if any of its components fail.
Driving over bumps causes loud, annoying noises in the body of the car. If the noise is a groaning or creaking, it can be improved by lubricating the rubber joints in the suspension system. If the noise is a rattling sound, the problem is likely wear and tear on the upper mounting plate for one or more of the suspension struts.