Problem with your car? See what our experts say or submit your own.
1996 Toyota Avalon Problems
The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
The Evaporative system may have problems with the vapor canister releasing charcoal pellets that plug the vent valve. Typically a Code P0441, P0442 and P0446 will be set. The key code is the P0446 which is a vent valve electrical failure. The proper repair is to replace the entire canister with all the valves as a unit. This is located on top of the fuel tank and is expensive. Our Technicians tell us that for awhile Toyota was covering these problems, but this may have changed. It would not hurt to call the dealer if this problem occurs to see if Toyota is still helping with these repairs.
The engine mount on the passenger side of the car can wear out on cars with high mileage. This will put extra stress on the other mounts and the faulty mount will need to be replaced.
On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.
A loss of power on the freeway may due to an internally leaking fuel pulsation dampener. This commonly occurs on higher mileage vehicles.
At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes. Be sure to check the condition and runout of the front wheel bearings on the 2WD and 4WD vehicles and the CV joints on the 4WD vehicles since worn wheel bearings and/or CV joints can cause the ABS trigger rings to rub against the ABS sensors and damage them.
At 125,000-150,000 miles, the Brake Master Cylinder may need replacing. When replacing the master cylinder, it is critical to adjust the brake pedal to master cylinder pushrod clearance or the brakes can drag and overheat.
A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.
As the size of the Camry vehicle gets ever larger, there is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, other wise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.
The Throttle Position Sensor can get out of adjustment due to wear in the throttle body or due to carbon build up. This will cause the idle timing to advance more than 30 degrees which will cause very high HC and NOx emissions. Conversely, the Throttle Position Sensors can wear out and not properly advance the timing which causes a lack of power and poor fuel economy.