Tires & More Complete Car Care

"You need a special tool made to seperate A/C lines / might be able to get one at Auto Zone through there loaner program. Good Luck !"

"This code comes on when carbon builds to the point of being a solid crystal, it's needs to be drilled completely out clear all passages to allow air flow again. Preventative in future would recd. f..."

"WOW ! 2K a bit steep I believe, I need a shop like his.
Tune Up using OEM NGK laser plugs $198.12
Ignition Wires if needed $119.99
Timing Belt V6 $249.99
Drive Belts if needed $79.99
Timing Se..."

"I would not do a re-seal, I would replace the engine with a quality used engine with low miles. The cost of that would be between 1500.00 to 2000.00 or replace with a quality Jasper engine 3yr - 10..."

"1st I would suggest not using a person that considers themselves a mechanic that can't test the system. I would definately do a compresion test and block test to start."

"Agree with the technician, it will in the end produce the best outcome from repairs"

"Depending on what is leaking and how severe, lots of people try to wait and say they will just add fluid as needed, but keep in mind that one day when your running late and forget to refill can be ..."

"Most likely dealer saying this, need to go online and google issue and see if parts are made seperatly."

"3-4 hours no longer unless a rookie performing service"

"Yes to replacement, need to jump them individually to test."

"Get documentation from dealership of what your issue was, with all of your documentation take him to small claims court. Oh and fire your mechanic."

"Absouletly agree with other answer, but I would push towards the cat converter not functioning 1st then move into Timing belt concerns. The belt should definetly be changed no later than 100k. We j..."

"This is a major part of your vehicle which is pretty labor intense. $457.00 is a very agressive price for a head gasket replacement. Labor hours are 5.2 hours which means he is charging you about $..."

"Go to your local Parts store with a picture of what the harness end looks like and they should be able to match it up, then all you will need to do is splice and cut to fit."

"Also if you goggle it you should be able to find diagrams on line for free."

"Believe it or not Fuel trim can give you a ton of answers to what is going on with your vehicle. I agree completely with the both answers, if you do not have a scan tool just check with your local ..."

"The buzzing noise is one of your relays going bad, most likely it is an intermitten proble. You will need to test the relays to see which one is bad."

"It sounds as if your clutch master cylinder is leaking or out of fluid. Go to google and enter clutch master cylinder for your car and it will show you where it is located so you can check fluid le..."

"Make sure whoever does the service uses BG chemicals to flush. "

"It could be numerous items causing issue,least expensive route is to start with checking for vacuum leaks."

"On the Mazda very simple procedure if you are unclear go to autozone.com they have online manuals or automd.com both are very helpful"

"Possible Intake Gasket leak, also check vacuum lines for leaks. Smoke test would be best for this situation, check with your local Technician."

"I agree with last answer, also a possibilty of high amount of exhaust fumes building up from a bad head gasket. a simple test to be done whould be a Block test your local automotive shop can perfor..."

"Yes, you have an interference engine if it breaks can cause valve damage"

"Between 50k-70k depending on driving habits
If the shocks air not leaking air the compressor should be fine the only time thay truly fail is when people let the shocks leak air for a long amount o..."