2004 Chrysler Sebring Q&A
2004 Chrysler Sebring Question: Timing Belt Replacement
Hi, This means that a fault has been detected by your engine control module. I would take it back to the shop that did the work, and they should look at it for you. It may or may not be related, but it's hard to know until you read out the fault codes. If you can get the code and post it here we can give you an idea as to what may be the cause. Good Luck! - Bret Bodas
Bring the car back, they could have left a wire off and you need them to diagnose this before you put too many miles on the car after the repair - Valleyautotech
AM TOLD I NEED TO REPLACE MY TIMING BELT ON '96 CHRYSLER CONV.; NO PROBLEMS YET, IT IT SO AND HOW MUCH WILL IT COST?
just bought car and was told it was out of time and the other guy had the dist out of it timng belt good and tight but will not fire thanks bob
when do the timing belt and radiator hoses need to be replaced before I have a problem.
I replaced the idler pullies and tensioner also the power steering pump. Had the alternator tested for noise but it's not there. When I take the serpentine belt off and start the motor the noise i...
Is it normal for a water pump to go out at 70000 miles? Also after coolent was put in because it was very low the car stopped leaking and also getting to hot. Is this normal?