1999 Chrysler 300M Q&A
1999 Chrysler 300M Question: thermostat replacement
there is a bleeder screw on top of the front of the motor. thanks for using repairpal Roy - mastertech6371
on the 3.5 engine which way dose the thermostat fit into the block? spring side frist or other,also when you bleed the cooling system is with the car running our off.
Drove it for 20 miles and it still didn't get very hot
Before refilling the coolant, make sure the air bleed valve is open. Follow the proper fill procedure—it will prevent problems with overheating, low heat output from the heater, and possib...
Poor output from the heater and/or engine overheating can be caused by air left in the cooling system after the cooling system has been serviced. Our technicians tell us the proper coolant fill pro...
I have had the my water pump, radiator, thermostat, intake manifold gasket replace and them temp gauge still goes high. I have to keep my heater blwoing high all the time so it does not over heat. ...