STARTING PROBLEM on 1990 Ford Bronco

MY 83 starts at times - and times it wont,BUT when it do'es when put in drive it stalls, please going carzy.

by in Carmichael, CA on February 25, 2010
3 answers
ANSWER by on February 25, 2010
Have you tuned this lately because just replacing the cap,rotor and spark plugs can make a big difference in performance and also if the carburetor is out of adjustment (air fuel mixture and idle adjustment screw ) the engine will not idle properly
ANSWER by on March 08, 2010
NO HAVENT TUNED IT , SHE BELONGED TO MY BROTHER ,(NOW PASSED AWAY) HE KEEP'T HER UP LOAND HER OUT WHEN GOT HER BACK SHE ACTING UP ,,,,,,,
ANSWER by on December 27, 2010
check the fuel filter. same exact thing happened to me and i replaced the filter and it fires up and stays running when i put it in gear
Related Items:
Failure is very common in the ignition module, causing intermittent stalling or a "No start" condition.
applied electret grease to the pcm and bulkhead connector, replaced the distributor electronics,r&r crank sensor,ignition mod on the driver fender, new plugs, all started when rain crank no start, ...
I have a 1990 Ford Bronco that after I drive it to town (20 miles there and 20 miles back) it starts to sputter, pop and back firer as I go up the mountain I live on. The clime is about 350 feet fr...
I have a 1990 Ford Bronco with 126,000 actual miles. Recenlty overhauled engine. New fuel pump, filter etc. For a while now, even before the overhaul, the truck was difficult to start at times. ...
Poor engine grounds could cause the engine not to start, intermittent Check Engine Light i...