SRS light stays on but there are no codes how is this reset on 2002 Honda Accord

I have disconnected neg cable and tried to reset with a OBDll scanner,hit reset button but didnt reset this car only has 47689miles on it

by in Cortez, CO on October 02, 2013
Get Your Car Fixed at a RepairPal Certified Shop.
We certify shops based on expertise, quality work, and verified customer reviews
2 answers 1 comment
ANSWER by , October 02, 2013
Did you check the fuse? Do that first. Then you can do this: Get a flashlight and a piece of wire about 3 ft long. 1. Locate MES Plug. It should be located near the driver's side fuse panel under the dash. The harness is yellow with two wires. 2. Unplug the MES Plug. It should look like this. 3. Insert one end of speaker wire into MES Plug (one wire in each contact) 4. Follow this sequence of shorting the other two leads of the speaker wire and turning the ignition to "on" (not accessory, not start) Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal. The SRS Light should illuminate for a couple of seconds as normal and then go off. This series of shorting/unshorting needs to take place within a 4 second window of the SRS Light going on/off each time. Check for images. IF THE CODE RESETS IN YOUR SENSOR THAN SOMETHING ELSE IS WRONG. THIS SYSTEM CAN SAVE YOUR LIFE. IF IT RESETS AND THE CODES APPEAR AGAIN HAVE A DEALERSHIP GIVE YOU A DIAGNOSTIC PRINT OUT ON YOUR CAR.
COMMENT by , January 16, 2015
i have a accord 2010 i turn car on the srs light stays on and does not blink at all i but code reader it says there are no codes i disconected the passngerseat to see if the passnger light turnson so i belive that is the srs module what do u think no codes the light stays on no blink anything i belive when i bought the car the module was wed or can it be something else
ANSWER by , October 03, 2013
agree with #1