Southtowne Collision Center
(770) 253-1407
Newnan, GA 30265
Hours of Operation
| Mon - Fri | 8:00am to 6:00pm |
| Sat | 9:00am to 2:00pm |
| Sun | CLOSED |
Message from the Shop
Free Estimates
We Offer;
We repair all makes and models
All our work is warranted as long as you own the car
Complementary car wash and vacuum after every service
Complete Unibody and Frame repair
Factory trained Professionals
I-CAR and ASE Certified Technicians
No appointment needed
State of the art Blowtherm paint booths
State of the art Chief Genesis frame measuring and pulling equipment
We accept any and all insurance estimates
Non insurance related repairs welcome
Over 200 years combined experience
We proudly use Sickens paint and coatings
Full service Detail shop
Painless dent repair
|
Auto Makes We Service
|
Specialties
| Collision Repair & Paint | Service & Repair | Upholstery | Windshield/Glass |
Amenities
| Car Delivery | Car Pickup/Dropoff | Car Wash | Child Friendly |
| Coffee | Early Bird Dropoff | Free Inspection | Gas/Diesel |
| Heated Waiting Room | Open Saturday | Parts/Accessories | Rental Car |
| Service Guarantee | Shopping Nearby | Shuttle | Store |
| Towing |
Featured Shops and Dealerships
-
(470) 253-9729
4978 Cobb Parkway North
-
(470) 296-2163
6475 Peachtree Industrial Boulevard
-
(678) 820-3823
4450 Lawrenceville Hwy NW # M
-
(678) 820-3945
304 Dividend Dr. Bld#2
-
(404) 996-1825
1921 Howell Mill Road
Recent Answers by Southtowne Collision Center
"Take the door apart and see what the problem is. Most likely the "window regulator" will have to be replaced."
"BAD DO-DO.
It would appear that you have a coolant / oil intermix. DO NOT CONTINUE TO RUN THE ENGINE!!! Find the source of the leak and repair it. Then flush the oil system. Most likely cause is ..."
"You can use a hack saw blade down in the middle of it to cut it into. After that you use a small punch to get the last little bits out. Then you use a tap to clean the threads. If you aren't good o..."
"1992 is the last year it's even close to possible. 1993 is the first electric valve body. Even with this the convertor clutch wiring will be different. If you can swap the convertor clutch controls..."
"The heat blend doors and other doors that control air flow are controled by little electric motors. They can go out as well as the control. It usually leaves trouble codes."
"This is probably an "automatic 4X4" system. The most common failure is the encoder motor. It's not cheap. "
"Only if it's malfunctioning."
"GOOK LUCK!!. Chrysler was never very good at keeping repair parts for very long and since the Crossfire was a hybred (Chrysler Mercedes) they didn't keep very much very long."
"Damage from a stripped timing belt is immediate and obvious. If the engine did not skip or miss after the belt was replaced, there was no damage. The water pump is a different story. If it went out..."
"CRANK POSITION SENSORS WERE NOTORIOUS FOR THIS."
"Take the glove box down and look for the "Blower Resister". You will probably find wires melted into the connecter. It was a common problem. Will need the connector "pigtail" spliced in and a new r..."