The Check Engine Light may Illuminate Erroneously on Chrysler Crossfire

"False" trouble codes may cause erroneous illumination of the Check Engine Light. Updating the PCM software can often correct this concern.

RepairPal Verified
Average mileage: 89,000 (89,000–89,000)
2 model years affected: 2004, 2008
4 people reported this problem
2 people shared problem details
29 Error Codes. Took five months to get check engine light to remain off and pass emissions test required by North Carolina. Replaced all four O2 sensors, catalytic converter, various relays and finally after receiving only eight error codes it went off on its own after about three weeks. Nothing else was done after the last check that had eight error codes except conducting diagnostics repeatedly over the three week period. Now at 111,000 it's showing errors again. Replaced O2 Sensors and still getting error codes. Dealer service department said they could change out the PCM but couldn't promise it will help.
Check engine light on and nothing wrong also key won't start the car.
Related Items:
get check engine light & no power if car is redlined. disconnect battery to reset computer then...
WHERE IS ECM ON MY 2004 CROSSFIRE
Replace relay bank module 397.00 dollars
I have no DRB-2scanner,just a 2005 service manuals 1-3 which section 7-1 thru 7-11 sugggests it...
The heater fan stays running when we shut the car off. The only way we can get it off is to un...

Related Content