Q&A
Ask Your Question1994 Plymouth Voyager
Question: sliding door rear latch doesn't work
Question
san holo, 2.5L 4 Cylinder, Arden, NC, August 31, 2010, 16:10
Rookie
A part in the rear latch of the sliding door is worn and blocks the pin from entering the latch properly when closing. How do I remove and replace the rear latch? The three hex screws are easy to remove, but it is not obvious how to remove the old latch and add a new one.
1 Answer
Flag This
-
Answer #1
Johnny Mopar September 14, 2010, 13:47Reply
MasterYou will have to open the sliding door, remove the trim panel, remove the rod links to the latch and remove the latch assy. Also, check alignment of the door to make sure the door is not sagging at the rear and adjust a necessary.
Flag ThisLike0
Answer Ranks
This week's top 10
| 1 globalhelper | 6 obdcar |
| 2 milesauto | 7 TimGoodreau |
| 3 csubak30 | 8 raiderron |
| 4 jose8889 | 9 Merrimack Auto |
| 5 Autohaus Lake Norman | 10 Camster |