2007 Saturn Vue Questions

Unanswered 2007 Saturn Vue Questions

Ask a Question
View:RecentAnsweredUnanswered
No accelerator or engine kill either, just not going forward. Good shop changed sensors(PO135-Sensor Heater Cir Bank 1, P2138-Trhrottle pedal position sensor/switch d/e voltage correlation, PO031 02 S-Heater Control ...
Was at GM dealership and was told I need to replace my intermediate shaft bearing? What is the estimate cost? What else will need to be replaced? The 2007 Saturn Vue is starting to rattle and make noise in the front?
hub and sensor were replaced codes co245 & co036 showed up could anyone tell me what to look for I did notice that the sensor has 2 spacer between the sensor and hub
New rotors drums and pads replaced 6 months ago. New wheel bearing assembly replaced 1 month ago. Every time brake pedal applied there is a slight push back on the pedal at the same time there is a noise heard like a ...
Error code C0035 prompted me to replace left front wheel hub and speed sensor. ABS and TC lights are still on and error code is now reading left front malfunction. What is next step?
It might stay off for a week and then comes back, but car runs good.
pressure are building up in brake line not allowing fluid to flow through,caluibars are not releasing
low mileage but it was in a front end crash, body is fully repaired, but the locks keep opening/closing while driving and the dash and tail lights aren't working.
I replaced the compressor, the accumulator,and the expancion valve, flushed the system and charged the system. It still does not cool. Can anyone help or tell me where I can a repair manuel.
A month after buying the engine started missing and two check engine lights came on. One is the power down light (?), which I'm told is rare. Dealer couldn't look at it except when it was doing it. Finally got it in a...
Going downhill on the freeway 65-67 mph and I lose power to the gas pedal for up to 20 seconds. The engine stays on, but doesn't rev, no lights come on, the RPM gauge looks to be stuck on the number 2. I can press the...