2.0L engines may become low on engine coolant with no cause found for the coolant loss. Our technicians tell us than in some cases the engine block may require replacement due to porosity.
2003 Saab 9-3 Problem Reports
RepairPal Verified 2003 Saab 9-3 Problem Reports
The head gasket may leak oil externally. The oil will be visible around the cylinder head and block area.
The thermo contact in the AC compressor can fail, which means the compressor may fail to engage or disengage.
The exhaust flex pipe can fail causing excessive exhaust noise from the front/center area of the vehicle. The flex pipe is a flexible joint in the exhaust that allows for engine movement.
If the battery "goes dead" after sitting for several hours, but only when key is left in the ignition, in the "off/lock" position. The problem may be with the stereo amplifier staying on. Our technicians tell us reprogramming the affected control module can remedy this problem.
The third brake light and/or license plate lamp may fail due to wiring damaged from rubbing on the trunk lid handle. Our technicians tell us the repair involves correcting the damaged wiring and isolating the connectors so they do not contact the trunk lid handle.
A knocking noise while turning and/or a banging noise when driving on rough roads may develop in the front suspension. This type of noise is commonly caused by a front strut thrust bearing damaged due to water intrusion. Our technicians tell us revised thrust bearings are available to correct this concern.
The shaft for the air blend door can fail creating the inability to adjust the AC or heating temperature. The AC or Heat will not maintain the proper temperature.
Snapping or popping noise heard from the steering shaft usually means the steering shaft joints need to be removed and re-installed using thread locking compound on bolts.
Our technicians report failures of various components in the audio system. Speaker, control unit, and steering wheel button failures are all possible.