Q&A

1999 Chevrolet Venture

Question: replacing water pump

Question

gtbrass, Eutaw, AL, March 22, 2009, 05:34

 Rookie

how do i separate the pulley shaft from the pump assembly? there are four bolts on the pulley, do i need a pulley puller? my engine is a 3.4

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  hemicuda March 23, 2009, 13:45
  

   Master

  Once the water pump is removed, Remove the four bolts from the pulley and wiggle it loose
  Reply
  Flag This
  Like | 1 person likes this1

• Leaking Water Pump May Cause Coolant Loss and Overheating
  A coolant leak may develop from the water pump. The engine may overheat as a result of the cool...

  Common Problems > Chevrolet Venture

• Water is getting in the oil, just put on a new water pump. What can be wrong now?
  Just started last week. Leak under van replaced water pump, changed oil and filter. Looks like oil may have some water in it. Checked engine cold it's ok, after running for a few minutes looks like...

  Q&A > Chevrolet > 2003 Chevrolet Venture

• My engine sounds like itis not getting enough power to keep it going.
  There is no diagnostic code. The tests thst were done show no electrical problem. None of the warning lights on the dashboard come on. It only cut off once and was easly turned back on again. No...

  Q&A > Chevrolet > 1999 Chevrolet Venture

• hot coolant temp
  my van overheated tonite with a hot coolant temp msg. i added more coolant and it still does it. the are no signs of puddle leaks in front...

  Q&A > Chevrolet > 2003 Chevrolet Venture

• What would the cost be for a motor and labor for this van
  I have 226,000 miles on it. It is still running good but it cant last. I have just replaced the transmission.

  Q&A > Chevrolet > 1997 Chevrolet Venture